Hi there, first post so here goes!

I need to get a manual release key for my electric gates but cannot identify the make. The release key hole is a hollow cylinder with two ridges inside. I attach some pics which may assist. Could anyone tell me what I'm looking for and where I might source it?

Many thanks

Gerry

               

Hi Gerry, looks very similar to the Proteco make of gground motor, i do have some release keys in the factory, if you could measure the diameter of the hole to double check the keys i have will fit?

let me know, many thanks

carl

This post was last modified: 05-16-2009 12:07 AM by easygates.

Hi Carl,

That's great - I'll measure the diameter and get back to you.

Cheers and thank you

Gerry

This post was last modified: 05-16-2009 12:07 AM by easygates.

Hi Carl

The diameter of the hole on the gate is 15mm.

I look forward to hearing from you.

Many thanks

Gerry

This post was last modified: 05-16-2009 12:08 AM by easygates.

Hi Gerry,

Thats the size of my release levers i have, PM me your address and i will send you one,

thanks

Carl

For you information Gerry
The releases and motors and releases you posted are the saimatic sub motors
as seen here
http://www.theelectricgateshop.co.uk/lat...=&offset=0

replaced 2 of these motors recently