Post Reply  Post Thread 
Remote Control
Author Message
Steve
Junior Member
**


Posts: 2
Group: Registered
Joined: Dec 2008
Status: Offline
Reputation: 0
Post: #1
Rolleyes  Remote Control

Hi all

I have installed a Chamberlain LiftMaster electric gate system and came across some problems when first trying to activate the gates.

I was able to get the sensors programmed ok but when I tried to program the remote control. When I pressed the CH1 button the LED did light up & I pressed the remote control button to program it but nothing happened. I tried to do it again for the second remote but nothing happened. Later I tried to clear the memory but also nothing happened.

Any help or ideas would be welcomed.

Regards Steve

12-09-2008 01:49 AM
Find all posts by this user Quote this message in a reply
Mark
Administrator
*******


Posts: 32
Group: Administrators
Joined: Jul 2008
Status: Offline
Reputation: 0
Post: #2
RE: Remote Control

Have you inserted the radio card onto the control panel?




Easygates Technical Support Team
12-09-2008 10:21 PM
Find all posts by this user Quote this message in a reply
Steve
Junior Member
**


Posts: 2
Group: Registered
Joined: Dec 2008
Status: Offline
Reputation: 0
Post: #3
RE: Remote Control

Mark Wrote:
Have you inserted the radio card onto the control panel?


Hi Mark

Yes I have inserted the radio card onto the control panel

Stephen

12-09-2008 10:54 PM
Find all posts by this user Quote this message in a reply
Mark
Administrator
*******


Posts: 32
Group: Administrators
Joined: Jul 2008
Status: Offline
Reputation: 0
Post: #4
RE: Remote Control

Sounds like you have a problem with it somewhere i would ring the supplier and go through a few test on the telephone with them whilst you are at the gate.




Easygates Technical Support Team
12-16-2008 02:29 AM
Find all posts by this user Quote this message in a reply
David Brisland
Junior Member
**


Posts: 3
Group: Registered
Joined: Mar 2009
Status: Offline
Reputation: 0
Post: #5
RE: Remote Control

Mark Wrote:
Sounds like you have a problem with it somewhere i would ring the supplier and go through a few test on the telephone with them whilst you are at the gate.


did you get this problem solved as i am having exactly the same problem

03-20-2009 06:07 AM
Find all posts by this user Quote this message in a reply
easygates
Administrator
*******


Posts: 44
Group: Administrators
Joined: Jul 2008
Status: Offline
Reputation: 0
Post: #6
RE: Remote Control

David Brisland Wrote:
did you get this problem solved as i am having exactly the same problem


Hi, Make sure the radio card is connected correctly and all pins are connected. Try taking it out and re-inserting it just to make sure you have it plugged in correctly.

Have you tried another remote control? Or replaced the batteries in the one you are using?

Have you set up the photocells? you do this by turning the power off, placing a jumper over the terminals labelled "Save Fail Safe Photocells", then turning the power back on and removing the jumper after 15 seconds.

Check the "Stop" circuit is connected, there should be a link between "Stop" and "Com".

Hope this helps,


Ste
Technical Support
Easygates Ltd
http://www.easygates.co.uk
ste@easygates.co.uk
0845 054 50 70
04-23-2009 01:17 AM
Find all posts by this user Quote this message in a reply
Post Reply  Post Thread 

View a Printable Version
Send this Thread to a Friend
Subscribe to this Thread | Add Thread to Favorites
Rate This Thread:

Forum Jump: