Post Reply  Post Thread 
Problem Setting Limits on CB24 (SCS300-24)
Author Message
Guest
Unregistered


Post: #1
Problem Setting Limits on CB24 (SCS300-24)

Can anyone help.
I cannot move to the next stage when setting the limits.
CB 24 circuit board.
I have set the open limit and then the close limit and saved it but the light just switches between the two limits and will not go out.
I have tried both sequences open 1, open 2, close 1, close 2 as per the manual and open 1, open 2, close 2, close 1, as per the tech support advise but I cannot move to the next stage to operate both gates with the remote or push button to set the power.
thanks
Andy.

This post was last modified: 05-16-2009 12:12 AM by easygates.

10-18-2008 07:45 PM
Quote this message in a reply
DQuinn
Junior Member
**


Posts: 2
Group: Registered
Joined: Nov 2008
Status: Offline
Reputation: 0
Post: #2
RE: SCS 300-24

I'm having the exact same problem. Has anyone a solution please?

DQuinn

11-02-2008 07:08 PM
Find all posts by this user Quote this message in a reply
Mark
Administrator
*******


Posts: 32
Group: Administrators
Joined: Jul 2008
Status: Offline
Reputation: 0
Post: #3
RE: SCS 300-24

DQuinn Wrote:
I'm having the exact same problem. Has anyone a solution please?

DQuinn


This results because the arm is not moving for at least 60% of it travel.

You need to use at least 60% of the motors travel so that they can recognise the limits




Easygates Technical Support Team
11-04-2008 03:18 AM
Find all posts by this user Quote this message in a reply
DQuinn
Junior Member
**


Posts: 2
Group: Registered
Joined: Nov 2008
Status: Offline
Reputation: 0
Post: #4
RE: SCS 300-24

Thanks, Problem solved.

11-09-2008 07:23 AM
Find all posts by this user Quote this message in a reply
Post Reply  Post Thread 

View a Printable Version
Send this Thread to a Friend
Subscribe to this Thread | Add Thread to Favorites
Rate This Thread:

Forum Jump: